From 1 - 4 / 4
  • The shooting ranges map shows the distribution of shooting ranges authorized by the Minister of the Environment under the legislation on classified establishments. It should be emphasized that the coordinates of the shooting ranges shown are approximate.

  • The amended law of 9 May 2014 on industrial emissions, which transposes Directive 2010/75/EU of the European Parliament and of the Council of 24 November 2010 on industrial emissions, aims to achieve integrated prevention and reduction of pollution from establishments. The rules set out aim to - prevent and reduce the pollution caused by industrial activities, - avoid, or, should this be impossible, reduce emissions to air, water and land, - prevent the generation of waste in order to achieve a high level of protection of the environment taken as a whole. The industrial activities giving rise to pollution are referred in the different chapters and annexes of the law. It differentiates between following categories: - activities listed in annex I (various activities), - large combustion plants, - waste incineration plants and waste co- incineration plants, - installations and activities using organic solvents, - installations producing titanium dioxide. An installation can fall under one or more of those categories. In Luxembourg the law applies to over 60 plants, approximately two third of those are activities listed in annex I.

  • The present location map shows the distribution of wind turbines authorized by the Minister of the Environment under the legislation on classified establishments. Depending on the data availability, information on the installed power, hub height and diameter of the propeller can be consulted. "Autorisé" is the project of a wind turbine that has been authorized under the legislation on classified establishments, while "existant" is a wind turbine built by the constructor and according to the implementation report. It should be noted that the coordinates of existing wind turbines listed in the authorization files do not always correspond exactly to the coordinates of the actual locations of the wind turbines after construction, and may vary slightly depending on the construction. Where applicable, the coordinates of wind turbines validated by an official surveyor are indicated by an attribute.